You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I haven't used a step spindle yet, but when the control board has 6-8 axes, use $xx=4-8 to bind a specific axis as a step spindle, which offers more flexibility. I'm not sure how difficult this will be, but I plan to use RP2350B later to make a 6-axis board.
Last time I said the serial handwheel response was poor, so I tried making a DB15 handwheel plugin (0X87 report using formats like "MPG:2,X(/Y/Z/A/B/C),x1(/x10/x100)"), using PIO to read the encoder, then sending $J. At low speeds shake the handwheel, the handwheel moves step by step; at high speeds, the speed is mapped to different feeds. The results are quite good. Maybe I can open source the plugin and then improve it yourself, so grblHAL supports native handwheels for all MCUs.
Do you have a use case or use cases for binding a configurable axis as a spindle? Adding a setting will increase complexity and interfere with a change I have in the pipeline.
Is your handwheel code is running on the controller or on a separate MCU?
Do you have a use case or use cases for binding a configurable axis as a spindle?
No. I don't know much about Step Spindle.
Is your handwheel code is running on the controller or on a separate MCU?
This is implemented using mpg_xxx.c plugins and modifying report.c files and other files, running on the controller. The plugin only starts working when axes are selected, so it hardly consumes extra performance.
Do you have a use case or use cases for binding a configurable axis as a spindle? Adding a setting will increase complexity and interfere with a change I have in the pipeline.
Is your handwheel code is running on the controller or on a separate MCU?
I have successfully changed the primary axis to use the $ configuration for selection. Now, it supports switching the primary axis by setting $SS to 0/1. It also allows for directional movement using commands like G1A30F400 when the primary axis is not enabled. Additionally, I have configured the system to use the $ setting to customize the names of axes 4-8, rather than using the default configuration at compile time. If the axis names are X/Y/Z, they act as secondary axes, emitting the same pulses as usual.
Activity
terjeio commentedon Jul 2, 2026
Do you have a use case or use cases for binding a configurable axis as a spindle? Adding a setting will increase complexity and interfere with a change I have in the pipeline.
Is your handwheel code is running on the controller or on a separate MCU?
XYartlab commentedon Jul 2, 2026
XYartlab commentedon Jul 28, 2026
I have successfully changed the primary axis to use the $ configuration for selection. Now, it supports switching the primary axis by setting $SS to 0/1. It also allows for directional movement using commands like G1A30F400 when the primary axis is not enabled. Additionally, I have configured the system to use the $ setting to customize the names of axes 4-8, rather than using the default configuration at compile time. If the axis names are X/Y/Z, they act as secondary axes, emitting the same pulses as usual.